Faulty analysis of laser cutting machine

Boot but no response: Under normal circumstances, the external input power machine, laser tube, chillers, pumps, fans, air compressors and other random accessories by "YM series of instructions" connected, open the back of the machine red "Total power switch", will hear the machine "beep", "tick" two sound, X / Y-axis automatically back to the origin. LCD screen on the control panel will be displayed.

Before laser cutting machine leaving the factory, we will install the device driver associated with the machine control panel where. If the machine is normal at this time, the buttons on the control panel can be properly used, can be directly linked to on the computer for processing the input file. If the boot prompt computer operating software, "can not detect the laser equipment", there may be failure or USB communication interface, the machine in question, a simple approach is to replace the USB data cable or the replacement of another computer and try again. If not, please call the Han Yueming laser repair.

If laser cutting machine is powered LCD panel does not show; button panel did not respond; X / Y axis not action: Check the connector contact is good, the power cord is normal; If the LCD panel showing, but the buttons did not respond, X / Y axis is not movement or action is not normal. Check the machine parameters are set correctly (see the detailed setting method "YM series of instructions" on page 52 in "Machine parameters").