Wood engraving is most widely used for die boards, wood model, wood parquet, hanger sculpture, wooden photo frame and so on. Wood materials can be divided into plywood, solid wood, MDF,  plywood is the most common one.

General speaking, plywood with the thickness of 3mm, 5mm, 7mm, can be cut bylaser cutting machine, the normal cutting speed of 3mm plywood is about 1.2 m / min, and can be fully cut through, and some solid plate can be cut for 10mm, all this depends on the the material. For 6mm die board, it is best to use 63.5mm focusing mirror, the rate of 0.2-0.4 m / min, light intensity of 75-80%, with a large air pump or air compressor, the effect is better. Cutting wood model follows the general thickness of 3 mm, the general speed is 0.5-1.2 m / min. General with parquet veneer cutting double-focusing mirror, demanding customers, try to use radio frequency management. Delicate spot because the RF tube, and cut a small slit. Hanger sculpture - the sculpture is best to choose a small arealaser engraving machine. Wood carving based on the size of graphics, effects and set the machine speed requirements. Some customers want to carve more black, you can choose from the focus sculpture. Size affects the degree of pump burned.

For the cutting and engraving of hot drilling template , most commonly used materials for drilling template cutting are : drilling hot paper, carving (MDF) or thin acrylic, cut paper, commonly used hot drilling 50mm Focus Lens, open blowing and suction wind, will be adsorbed on the honeycomb cardboard flat on the process of cutting parameters and no special requirements, cutting parts of the graphics do not too much, speed is generally 0.5-3.5 m / min, light intensity is generally about 18-40 as much as possible to increase blow to reduce the cut edge of the color situation. Drilling hot plate engraving speed of 10 m / min, light intensity of 35%, resolution of 600 dpi or more. Depends on the size of the specific drilling hot, hot drilling the greater thickness of thick hot drilling, drilling hot plate had to be carved deeper.